Daily Maintenance Checklist - Toro Multi Pro 5800 Operator's Manual

Maintenance Service
Interval
Every 400 hours
Yearly
Important:
Refer to your engine Operator's Manual for additional maintenance procedures.

Daily Maintenance Checklist

Duplicate this page for routine use.
Maintenance Check Item
Check the brake and parking brake
operation.
Check the neutral lockout switch
operation.
Check the fuel level.
Check the engine oil level.
Check the hydraulic oil level.
Check the coolant level.
Inspect the air filter.
Inspect the radiator and oil cooler for
debris.
Check any unusual engine noises.
Check any unusual operating noises.
Check the tire pressure.
Check for fluid leaks.
Check all hydraulic and fluid hoses for
damage, kinks, or wear.
Check the instrument operation.
Check the accelerator operation.
Clean the suction strainer.
Maintenance Procedure
• Grease the actuator rod bearings.
• Complete all yearly maintenance procedure specified in the engine operator's
manual.
• Check the fuel lines and connections.
• Drain and clean the fuel tank.
• Replace the fuel filter canister.
• Replace the in-tank fuel filter.
• Pack the front wheel bearings.
• Change the planetary gearbox fluid.
• Check the coolant (as directed by the manufacturer) and change if necessary.
• Replace the hydraulic oil filter.
• Change the hydraulic oil.
• Inspect the O-rings in the valve assemblies and replace them if necessary.
• Inspect the pump diaphragm and replace if necessary. (see an Authorized Toro
Service Distributor)
• Inspect the pump check valves and replace if necessary. (see an Authorized Toro
Service Distributor)
• Inspect the nylon pivot bushings.
• Flush the sprayer with clean water using the Cleaning the Sprayer procedure.
During the rinse procedure, increase pump speed to open relief valve; purging
valves and hoses of residual fluids.
• Calibrate the agitation bypass valve.
For the week of:
Mon. Tues. Wed. Thurs.
31
Fri. Sat. Sun.