Toro Multi Pro 5800 Operator's Manual page 18

1. Cruise control switch
2. Agitation
3. Pump switch
4. Foam marker switch, left
boom (optional)
5. Foam marker switch, right
boom (optional)
6. Boom lift switch, right
boom
Pump Switch
The pump switch is located on the control panel to
the right of the seat (Figure
forward to run the pump or rearward to stop the pump.
When the switch is turned on, a light on the switch
illuminates.
Important:
Only engage the pump switch when
the engine is at low idle to avoid damaging the
pump drive.
Boom Lift
The boom lift switches are located on the control
panel to the right of the seat and used to raise the left
and right booms respectively
Agitation Switch
The agitation switch is located on the control panel to
the right of the seat (Figure
forward to turn on the agitation in the tank or rearward
to stop the agitation. When the switch is turned on, a
light on the switch illuminates. For agitation to work,
the pump must be on and the engine must be running
Figure 13
7. Boom lift switch, left boom
8. Boom switch, right boom
9. Boom switch, center boom
10. Boom switch, left boom
11. Throttle lever
13). Toggle this switch
(Figure 13).
13). Toggle this switch
above an idle. The agitation valve is located behind
the tank (Figure
1. Agitation valve
Agitation Bypass Valve
The agitation bypass valve redirects the fluid flow to
g013754
the pump when you turn off agitation
It is located at the back of the agitation valve. You
can adjust this valve to ensure that pressure remains
constant during agitation. Refer to Calibrating the
Agitation Bypass Valve in the Operation section.
1. Agitation bypass valve
Agitation Control Valve
The agitation control valve is a manual ball valve that
controls flow to the agitation nozzles in the main tank
(Figure 16). Using this valve allows the user further
control over pressure at the agitation nozzles of the
main tank when larger application rates are required.
18
14)
Figure 14
2. Boom valves
(Figure
Figure 15
g014346
15).
g014358