Cleaning; Cleaning The Suction Strainer - Toro Multi Pro 5800 Operator's Manual

Cleaning

Cleaning the Suction
Strainer
Service Interval: Before each use or daily
1. Position the sprayer on a level surface, set the
parking brake, stop the pump, stop the engine,
and remove the ignition key.
2. Remove the retainer from the red fitting attached
to the large hose on the top of the tank
66).
Figure 66
1. Suction hose
3. Disconnect the hose from the tank
4. Pull the suction strainer out of the hole
67).
Figure 67
1. Suction strainer
5. Clean the suction strainer with clean running
water.
6. Replace the suction strainer, seating it fully into
the hole.
(Figure
g002257
2. Retainer
(Figure 66).
(Figure
g005491
7. Connect the hose to the top of the tank and
secure it with the retainer.
55