Spray System Maintenance; Inspecting The Hoses - Toro Multi Pro 5800 Operator's Manual

8. Stop the engine, check the hydraulic oil level,
and check for leaks.
9. Dispose of the used oil at a certified recycling
center.
Checking the Hydraulic Lines and
Hoses
Inspect the hydraulic lines and hoses daily for
leaks, kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration and chemical
deterioration. Make all necessary repairs before
operating.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Ensure that all hydraulic fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pin hole leaks or nozzles that eject high
pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Get immediate medical help if fluid is
injected into skin.
Spray System
Maintenance
WARNING
Chemical substances used in the spray
system may be hazardous and toxic to you,
bystanders, animals, plants, soils or other
property.
• Carefully read and follow the chemical
warning labels and Material Safety Data
Sheets (MSDS) for all chemicals used and
protect yourself according to the chemical
manufacturer's recommendations. For
example, use appropriate Personal
Protective Equipment (PPE) including
face and eye protection, gloves, or other
equipment to guard against personal
contact with the chemical.
• Keep in mind that there may be more than
one chemical used and information on
each should be assessed.
• Refuse to operate or work on the sprayer if
this information is not available!
• Before working on a spray system
make sure the system has been triple
rinsed and neutralized according to
the recommendations of the chemical
manufacturer(s).
• Verify there is an adequate supply of clean
water and soap nearby, and immediately
wash off any chemicals that contact you.

Inspecting the Hoses

Service Interval: Every 200 hours—Inspect all hoses
and connections for damage and
proper attachment.
Every 400 hours/Yearly (whichever comes
first)—Inspect the O-rings in the valve
assemblies and replace them if necessary.
Examine each hose in the spray system for cracks,
leaks or other damage. At the same time, inspect the
connections and fittings for similar damage. Replace
any hoses and fittings if damaged.
52