Greasing The Actuator Rod Bearings - Toro Multi Pro 5800 Operator's Manual

Right boom
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each boom pivot.
Greasing the Actuator Rod
Bearings
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Grease Type: No. 2 general-purpose lithium base
grease.
1. Extend the booms to the spray position.
2. Remove the cotter pin from the pivot pin
36).
Figure 35
g002014
1. Actuator
2. Actuator rod
3. Boom pivot pin housing
3. Lift up on the boom and remove the pin
36). Slowly lower the boom to the ground.
4. Inspect the pin for any damage, replace if
necessary.
5. Manipulate the actuator rod bearing end and
apply grease into the bearing
off excess grease.
(Figure
1. Grease bearing
6. Lift up on the boom to align the pivot with the
actuator rod. While holding the boom, insert the
pin through both boom pivot and actuator rod
(Figure
35
Figure 36
4. Cotter
5. Pin
(Figure
Figure 37
Right boom
36).
g013780
(Figure
37). Wipe
g002015