Lubrication; Greasing The Bearings And Bushings - Toro Reelmaster 5510 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (and immediately
after every washing).
Grease Specification: No. 2 lithium grease
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood; refer to
44).
3. The lubricate the machine at the fittings at the
locations as follows:
•
Pump-driveshaft U-joint (3)
Note:
The pump-driveshaft is located under
the hood.
Figure 66
•
Cutting-unit lift-arm cylinders (2 each)
(Figure 67)
Figure 67
44).
Opening the Hood (page
(Figure 66)
g003962
g012150
•
Lift-arm pivots (1 each)
•
Cutting-unit carrier-frame and pivot (2 each)
(Figure 68)
•
Lift-arm pivot shaft (1 each)
•
Axle-steering pivot (1)
•
Steering-cylinder ball joints (2)
46
(Figure 67)
Figure 68
(Figure
Figure 69
(Figure 70)
Figure 70
(Figure
g003960
69)
g004157
g004169
71)