Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (also after every
washing).
Grease specification: No. 2 lithium grease
The grease fitting locations and quantities are as
follows:
•
Brake-shaft pivot bearings (5) as shown in
36
Figure 36
•
Rear-axle-pivot bushings (2) as shown in
37)
Figure 37
•
Steering-cylinder ball joints (2) as shown in
38
Figure
g009704
1. Top fitting on kingpin
•
Tie-rod ball joints (2) as shown in
Figure
•
Kingpin bushings (2) as shown in
Important:
kingpin no more than annually (2 pumps).
•
Lift-arm bushings (1 per cutting unit) as shown in
Figure 39
g009705
•
Lift-cylinder bushings (2 per cutting unit) as shown
in
Figure 39
43
Figure 38
Figure 38
Figure 38
Lubricate the top fitting on the
Figure 39
Figure
g009706
g009707