Configuring The Ups For Ebms - Eaton 9155 User Manual

UPS Operating Instructions
Table 10. User Settings (Continued)
Description
Audible Alarms
Battery Charging
Automatic Battery Tests
Full Power Battery Test
Number of Battery Strings
Battery Capacity
Battery Low Alarm Level
Set Nominal Output Voltage
Bypass Voltage High Limit
Bypass Voltage Low Limit
Nominal Output Frequency
Synchronization
Synchronization Window
Unsynchronized Transfer to Bypass
Output Frequency Slew Rate
Usage of Bypass
Transfer to Bypass When Overload
Automatic Start Delay
Control Commands from X-Slot1
Control Commands from X-Slot2/Serv
X-Slot Signal Input Activation Delay
Input signal delayed shutdown delay
Site Wiring Fault Notice
Reset Custom Event Settings
Auto Output Configuration
46 Eaton 9155 Parallel UPS (8–15 kVA) User's Guide 164201592—Rev E0
Available Settings
Normal Sound/Disabled
ABM cycling/constant
Enabled/Disabled
Enabled automatically runs the battery test once a
month.
Enabled/Disabled
0 through 22
(see paragraph

5.3 Configuring the UPS for EBMs

for more information. )
1 through 65535 watts per cell
1.750 through 1.950 volts per cell
Output:
[120V/208V] [127V/220V]
+1 through +20% (1% increments)
-1 through -20% (1% increments)
50 Hz or 60 Hz
Enabled/Disabled
±0.5 through ±3.0 Hz
(0.1 Hz increments)
Allowed/Not Allowed
0.1 though 5 hertz per second
(0.1 Hz increments)
Enabled/Disabled
After a delay/Immediately
-1 through 32767 seconds
(-1 means disabled)
Allowed/Disabled
Allowed/Disabled
0 through 65 seconds
1 through 65535 seconds
Enabled/Disabled
0 through 32
Enabled/Disabled
Default Setting
Normal Sound
ABM cycling
Enabled
Enabled
2 strings for UPS-32 models
4 strings for UPS-64 models
34 W/cell
1.880 V/cell
120V/208V
120V +10%
120V -15%
60 Hz
Enabled
±2.0 Hz
Not Allowed
0.5 Hz/s
Enabled
After a delay
0s
Allowed
Allowed
5s
120s
Enabled
Total: 0/32
Enabled for initial startup
Disabled after initial startup