Table of Contents
Advertisement
C C h h a a p p t t e e r r 4 4 P P a a r r a a l l l l e e l l U U P P S S S S y y s s t t e e m m I I n n s s t t a a l l l l a a t t i i o o n n
4 4 . . 1 1
P P r r e e l l i i m m i i n n a a r r y y I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
Installation should be performed only by qualified personnel.
Refer to the following while installing the UPS system:
•
Review Chapter 3 UPS Installation Plan and Unpacking, for cabinet dimensions, equipment weight,
wiring and terminal data, and installation notes.
•
Do not tilt the cabinets more than ±10° during installation.
•
Remove conduit landing plates to add conduit landing holes as required.
•
If perforated floor tiles are required for ventilation, place them in front of the UPS.
4 4 . . 2 2
U U n n l l o o a a d d i i n n g g t t h h e e U U P P S S C C a a b b i i n n e e t t f f r r o o m m t t h h e e P P a a l l l l e e t t
The following tools are required for unloading the cabinet(s):
•
15 mm wrench or socket
•
7 mm nutdriver or socket
The UPS and Extended Battery Module (EBM) are heavy (see
two people to safely remove the cabinets from the pallet.
To remove the UPS or EBM from the shipping pallet:
1.
Remove the two M10 bolts securing the stabilizing bracket to the pallet (see
WARNING
CAUTION
Table
Eaton 9155 Parallel UPS (8–15 kVA) User's Guide 164201592—Rev E0
2). Unloading the cabinets requires at least
Figure
2).
15
Advertisement
Table of Contents
