Installing The Floor-Standing Column; Installing Cards In The Remote Ipe Module - Nortel 1000 Manual

•
Install the NT1P75 fiber-optic patchcords.
•
Connect the fiber-optic link to the optical I/O panel.
Note:
All Fiber Remote IPE modules or cabinets are installed in the
factory with cards already in their respective card slots. The only
exception is the power supply, which is packaged separately and must
be installed at the site.
Installing the floor-standing column
The column is normally assembled in the factory with cards already
installed and NT1P75 fiber-optic patchcords connected between the
NT1P62 Fiber Peripheral Controller card faceplate and the optical I/O
panel at the rear of the IPE module.
If the column is not assembled in the factory, to install the modular column
(floor-standing column) at the remote site, follow the instructions in
Communication Server 1000M and Meridian 1 Large System Installation
and Commissioning (NN43021-310) (). It describes how to install the
pedestal, the IPE module, and the top cap and how to connect the power,
the internal and external communication cables, and subscriber loops.
To install the PFTU to the floor-standing Fiber Remote IPE, follow the
instructions in Communication Server 1000M and Meridian 1 Large
System Installation and Commissioning (NN43021-310) ().

Installing cards in the Remote IPE module

The purpose of the following steps is to describe how and where to install
the cards in the Remote IPE module. Even though the cards were shipped
installed from the factory, step-by-step instructions are provided for card
installation. Follow these instructions when additional IPE cards are
installed or defective cards are replaced.
NT1P63 Electro-optical packlets, which are installed on the NT1P62 Fiber
Peripheral Controller card, are normally installed in the factory; however, it
may be necessary to install an additional NT1P63 Electro-optical packlet
onto the NT1P62 Fiber Peripheral Controller card to make a single
fiber-optic link into a redundant link.
To install these cards, follow the steps in
the Remote IPE module" (page
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Floor-standing column Fiber Remote IPE installation 61
62).
Nortel Communication Server 1000
Fiber Remote IPE Fundamentals
NN43021-554 04.01 4 June 2010
Procedure 6 "Installing cards in