Nortel 1000 Manual page 53

Procedure 2
Installing Superloop Network cards
Step Action
1 Set the ENB/DIS switch on the Fiber Superloop Network card
to DIS.
2 Pull the NT1P61 Fiber Superloop Network card's upper locking
device away from the faceplate and press the lower locking
device downwards.
3 While holding the card by these locking devices, insert it into the
card guides of the selected network card slot.
4 Slide the card into the module until it engages the backplane
connector.
5 Carefully push the upper locking device lever towards the
faceplate and the lower locking device upwards to insert the card
connector into the backplane connector and lock the card in
place.
6 If not already installed, install the NT1P63 Electro-optical
packlet(s) onto the NT1P61 Fiber Superloop Network card. Do
this by inserting the NT1P63 Electro-optical packlet, connector
first, through the NT1P61 Fiber Superloop Network card
faceplate opening and plugging it into the connector on the
NT1P61 Fiber Superloop Network card.
For consistency, install the NT1P63 Electro-optical packlet into
the top connector location if only one NT1P63 Electro-optical
packlet is required (for nonredundant link operation). Install
the blank packlet into the bottom connector location. For a
redundant link, install both NT1P63 Electro-optical packlets.
7 Install the optical I/O patch-panel, which is a part of the
NT1P76AA cable assembly, in the empty connector slot of the
module's I/O panel by screwing its top and the bottom screws
into the slot screw holes on the I/O panel.
Use one connector slot for the FC/PC optical connectors that
link the NT1P61 Fiber Superloop Network card and the NT1P63
Electro-optical packlets to the fiber-optic link, as shown in
9 "Fiber Superloop Network card patchcord connections in
Meridian 1 PBX 81C" (page
8 Use another empty connector slot in the I/O panel for the System
Monitor/TTY ports I/O patch-panel, also part of the NT1P76AA
cable assembly, as shown in
TTY cable connections" (page
Screw the top and the bottom screws of the cable's connector
bracket into the connector slot screw holes on the I/O panel.
Nortel Communication Server 1000
Fiber Remote IPE Fundamentals
NN43021-554 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Fiber-optic equipment installation 53
55).
Figure 10 "System monitor and
57).
Figure