Nortel 1000 Manual page 137

Table 19
Alphabetical list of MMI commands (cont'd.)
Command Description
EOIA on/of Default is off. Monitors EOI laser controller and
reports the result: #n= 0 (primary), #n=1 (secondary)
EOI #n ALARMS: Transmitter Fail
EOI #n ALARMS: Transmitter is OK
EOI #n ALARMS: Laser Fail
EOI #n ALARMS: Laser is OK
EOI #n ALARMS: Transmitter Input Clock Loss
EOI #n ALARMS: Transmitter Input Clock is OK
EOI #n ALARMS: Laser Degrade
EOI #n ALARMS: Laser Degrade is OK
EOI #n ALARMS: Laser ShutDown
EOI #n ALARMS: Laser ShutDown is OK
EOI #n ALARMS: Receiver Fail, alarm= x
EOI #n ALARMS: Receiver is OK
EOI #n ALARMS: Receiver Optical Input Fail, alarm= x
EOI #n ALARMS: Receiver Optical Input is OK
EOI #n ALARMS: Low Optical Input Power, alrm= x
EOI #n ALARMS: Low Optical Input Power is OK
EOI #n ALARMS: High Optical Input Power, alrm= x
EOI #n ALARMS: High Optical Input Power is OK
Changes the MMI port to local or MMI mode. ESC must be
the first character in the command and must be preceded
<ESC>L
with 1.5 seconds of no-input.
<ESC>R Changes the MMI port to remote or SL-1 mode. ESC
must be the first character in the command and must be
preceded with 1.5 seconds of no input.
Performs forced switch of the active span to PRI=primary
or SEC=secondary packlet.
FORC PRI/SEC
Displays the list of commands.
HELP
Query card ID information where M=main board (default
IDC M/P/S setup), P=primary packlet, and S=secondary packlet.
Nortel Communication Server 1000
Fiber Remote IPE Fundamentals
NN43021-554 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Replacing Fiber Remote IPE cards 137