Nortel 1000 Manual page 101

Table 11
Network superloop maintenance commands (cont'd.)
Maintenance
command
DSXP x
ENXP x
ENXP XPEC x
STAT loop
SUPL loop
XNTT loop
XPCT x
XPEC x
Fiber Remote IPE MMI maintenance commands
Fiber Superloop Network cards and Fiber Peripheral Controller cards
provide a Man-Machine Interface (MMI) port to connect a configuration
and maintenance terminal. Use this terminal to directly issue commands
to these cards to test and maintain fiber-optic equipment, including the
fiber-optic link.
Table 12 "MMI maintenance commands" (page 101)
For a detailed description of these commands, refer to
and MMI commands description" (page
alphabetical order.
Table 12 "MMI maintenance commands" (page 101)
directly issued to the system over the MMI terminal. They can be
connected to the Fiber Superloop Network card and the Fiber Peripheral
Controller card MMI port.
Table 12
MMI maintenance commands
Maintenance command
HELP
<esc>L
<esc>R
SUBM R
SU R
SDEF L/R
QDEF
Maintenance command description
Disables Peripheral Controller and all IPE cards
Enables Peripheral Controller and all IPE cards
Enables Peripheral Controller but not IPE cards
Displays status for one or all network loops
Prints data for one or all superloops
Self-test on a Network card for a specific loop
Self-test on Peripheral Controller x
Prints data for Peripheral Controller x
Maintenance command description
Displays the list of MMI commands
Changes the MMI terminal to Local mode
Changes the MMI terminal to Remote mode
Places the Fiber Superloop Network card in Remote mode
Sets Fiber Superloop Network card in Remote mode when
the MMI port is connected to an SDI port
Sets the default mode to Local or Remote
Checks the default mode of the MMI port
Nortel Communication Server 1000
Fiber Remote IPE Fundamentals
NN43021-554 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Diagnostic tools 101
list these commands.
"System messages
131), where they are listed in
lists MMI commands