Hendi 274125 User Instructions page 20

7.8.3 Fitting the tap
7.9. Internal sanitization
Warning the thermostat must be set to -OFF-
Carry out the following steps:
• prepare the sanitizing solution (see paragraph 7.7)
• fill the bowl with the sanitizing solution;
7.10. Cleaning the drip tray
EN
7.11. Cleaning the bowl lid
20
To fit the lap correctly back in place proceed as fol-
lows;
• hold down the button, making sure that the road is
completely extracted;
• introduce the tap into the seat provide and push un-
til the pushbutton returns to its initial position.
Fig. 42
• leave the solution to act for about 30 mins;
• empty out the sanitizing solution from the bowl;
Then rinse out the bowl and inside surfaces thor-
oughly to eliminate all residues of sanitizing solution.
The drip tray should be emptied and cleaned daily.
Note: the tray needs to be emptied out and cleaned
every time that the red float fitted to the grid rises,
this is to stop liquid from leaking out.
Lift the tray with grid and pull it outwards to remove it
from its seating.
Fig. 43
• wash the tray and grid separately with lukewarm,
water;
• dry all of the component
• reposition the grid on top of the tray;
• fit the tray back in place and press down to secure
it to the machine.
• Remove the bowl lid from the machine;
• Clean the surface using a damp cloth and / or a
non-abrasive sponge soaked in sanitizing product.
• Rinse thoroughly using clean water.
Fig. 44