Hendi 274125 User Instructions page 17

7.6. Disassembling the tap
To clean the inside of the tap more thoroughly, disas-
semble it as follows:
• Remove the tap, follow the steps listed in para-
graph 7.4;
• Place the tap on a clean, flat surface, then loosen
and remove the screw (A) fastening the button to
the machine, then slide out the pin (B) and relevant
Fig. 27
spring (C) from the seating.
• Pull the (D) all the way out from the knob (E) then
push the lever (F) upwards from the bottom until it
comes out from the pin guide, as illustrated in the
figure;
Fig. 28
• Unscrew the knob (E) by turning it anticlockwise
while holding the rod in place;
Fig. 29
• Pull out the rod (G) and spring (H) from the tap body
(the pin/gasket assembly (I) will slide out together
with the rod)
Fig. 30
• Detach the rod (G) from the pin/gasket assembly (I);
Fig. 31
• Disassemble (by pulling) the pin (L) from the gasket
Fig. 32
(M).
EN
17