Setting The Address At The Easyport Usb - Festo EasyPort USB D16A Manual

5. Layout and function
5.5
Setting the address
at the EasyPort USB
LCD panel at EasyPort USB with address display
112 112
Note
24 V DC power supply is fed externally to the EasyPort USB. It can be
connected either via ports 1 and 2, or via two isolated screw terminals
which are included on the back of the EasyPort USB.
Make sure that power supply is only connected on one side.
The address of the EasyPort USB is selected with the  and  scroll
buttons. The address setting mode is activated by simultaneously
pressing both buttons. An address within a range of 1 and 4 is selected
by pressing the  and  buttons. The address is saved and the address
setting mode is exited by pressing both buttons simultaneously.
All EasyPort USB process interfaces are set to a default address of 1 at
the factory.
PORT 3
0
PORT 1
USB RS 232
Error Status
IN
OUT
7 0
PORT 2
© Festo Didactic GmbH & Co. KG „ 721876
24V 0V
EasyPort USB
7