Switching The Display Data (Example: Maximum Value → Peak-To-Peak Value); Setting Values To The Display (Preset Function) - Magnescale LY71 Instruction Manual

1-6. Switching the Display Data (Example: Maximum value
peak Value)
Currently-displayed data can be switched.
1
Press the key on counter display B. (The ABS lamp flashes.)
2
Press the key twice.
3
Press the key. (The ABS lamp lights off or on.)
........ The value shown on counter display B changes to the peak-to-
peak value.
........ Peak-to-peak value =
MAX (maximum value) – MIN (minimum value)
Read and confirm the display data.
∗ Display data can be switched by an external signal. (See "2-16-3. Switching the display data from an
external device".)
∗ This procedure does not allow switching of the displayed axis. (For details about switching the axis, see
"4-3. Advanced Settings" in the Installation Manual.)

1-7. Setting Values to the Display (Preset Function)

This sets a value to the current value that is displayed.
1
Press the key on counter display A. (The ABS lamp flashes.)
2
Use the key to move the digit, and then use the numeric keys to enter the value.
3
Press the key.
........ This sets the entered value. At the same time, the restart function is activated, and the maximum
and minimum values are also set to the same value. (The peak-to-peak value becomes 0.)
∗ An entered value can be set from an external device using the preset operation. (See "2-16-10. Setting a
value input by Preset from an external device".)
∗ Counter display C is a reference display, and so it cannot be preset.
This completes the basic operations.
The next sections describe other operations and functions. Be sure to make the necessary settings in the
basic and advanced settings before using. (See "4. Settings" in the Installation Manual.)
LY71
1. Basic Operation
→ → → → →
Peak-to-
1-3
(E)