Relocation Of The Datum Point Position; Pausing Maximum Value/Minimum Value Calculation (Pause) - Magnescale LY71 Instruction Manual

2-4-2. Relocation of the datum point position

7
When the REF lamp is not lit on
Press the key. (The
8
Press the key. (The ABS lamp flashes.)
9
Press the key.
........ The stored value is displayed.
10
Press the key.
11
Move the measuring unit until it beeps. (The beeping sound is made when going past the reference
point.)
........ The count is started, and the datum point position is relocated.
∗ The datum point position can be relocated by input from an external signal. (See "2-16-6. Relocating the
datum point position with an external signal".)
∗ Counter display C is a reference display, and so it cannot perform reference point operation.

2-5. Pausing Maximum Value/Minimum Value Calculation (Pause)

When making continuous measurements of multiple objects to calculate the total maximum value and
minimum value, in some cases, the measurements will be updated to unneeded data unless they are stopped
before finishing. In these types of cases, perform the procedure below to temporarily stop calculation of the
maximum value and minimum value.
Measurement
q
Example 1 The measuring unit is moved outside the
measurement range between q and w.
1
Select in the Hold setting.
➔ Installation manual "4-3. Advanced Settings" (Hold function)
2
Press the key. (The
........ The calculation of the maximum and minimum values is paused.
Restarting
Press the key. (The
LY71
lamp lights on.)
w
lamp lights on.)
lamp lights off.)
Example 2 Pause
2. Applied Operation
2-3
(E)