Magnescale LH71 Operation Manual

LH71/72
Tool offset function
Operation manual
START
Table of contents
1. First of all
2. Target model
3. Front panel
4. Positional relationship between TOOL master (reference) and other TOOLs (conceptual diagram)
5. Settings
and operations
1. First of all
The tool offset function is used in absolute mode (ABS). You must set up a tool master to use this function. The
coordinate position of each tool is a coordinate value managed by the offset amount with respect to the tool master.
Therefore, if you change the value of the tool master, the coordinates of other tools will change automatically.
The tool master is set to number 1 in the factory settings, but in this operation manual, the tool master is set to a tool
number that is not normally used. Then, in the actual operation, we will explain how to set and operate only the tools
that are normally used without using the tool master.
NOTE: Set the X-axis display setting to diameter display (Φ lamp lights up).
OPERATION FLOW
STEP １
Change tool
master number coordinate settings
Contents
Change tool master number
STEP １
Tool master coordinate setting (for scale with reference point)
STEP 2-1
Tool master coordinate setting (for scale with reference point)
STEP 2-2
Setting the number and offset value of the tool to be used
STEP 3
LH71/LH72 Tool offset function Operating manual
STEP 2
Tool master Setting the number
and offset value
Ver. 3 (2021.1)
LH72
Finished
STEP 3
Page
1
2
2
2
3
3
4
5
CS&S
1/5