Maximum Allowed Heating Time - Fasel Elektronik FCU2000 Series Operating Manual

Heating time
The heating time is the operating time for
the "Steam bath" mode.
The heating time can be adjusted if the
lamp next to the "Steam bath" mode key
flashes.
Table: 6 Heating time / remaining heating time
1.
2.
3.
4.
Fig. 5: "Change values" view (example)
5.
6.
7.
5.4.1

Maximum allowed heating time

After starting a mode, the remaining heating time is displayed in place of the full heating
time. The heating time can be changed only in standby mode.
Operating manual Steam bath control Series FCU2000/FCU3000/FCU4000 B_FCUxxxx-Steam_EN / Version V 2.03
The timer may be enabled or disabled depending on the setting. In the series
FCU2000-Steam and FCU3000-Steam, weekly timer is not available.
The "Steam bath" (Fig. 4) is displayed.
Press the key till the symbol
Press the key.
Following view is displayed:







Press the key. Last digit flashes.
Adjust the desired value:
Press the key: Reduce value.
Press the key: Increase value.
Note!
After the digit "9" or "0", the higher digit of the temperature value is changed. That
is "40" is displayed after "39".
You can also select the higher digit using the
Press the key. The "Steam bath" view is displayed again.
Remaining heating time
The remaining heating time is the re-
maining time when the "Steam bath"
mode is turned on. The remaining heat-
ing time is reduced automatically.
The remaining heating time can be ad-
justed if the lamp next to the "Steam
bath" mode key lights up.
The modified remaining heating time
does not change the programmed heat-
ing time.
(adjust temperature) lights up.


key or
Operation

key and then change.
19