Weekly Timer On/Off (Only For Fcu4Xxx); Program The Weekly Timer - Fasel Elektronik FCU2000 Series Operating Manual

10. Select desired weekday. Check mark flashes.
11. Press
12. Leave menu with
6.1.2

Weekly timer ON/OFF (only for FCU4xxx)

The timer appears only if the weekly timer is enabled. In this menu you can enable the
weekly timer (enable Service menu).
1.
Fig. 17: Weekly timer enabled. – Check mark not set (example)
2.
3.
4.
5.
Fig. 18: Start time (example)
6.1.3

Program the weekly timer

The timer appears only if the weekly timer is enabled.
In this menu, you can set the weekly program. You can program 2 start times for each
day.
1.
Operating manual Steam bath control Series FCU2000/FCU3000/FCU4000 B_FCUxxxx-Steam_EN / Version V 2.03
Press -key: move cursor left.
Press -key: move cursor right.
-key. Selection is saved.
Following view is displayed:








Press the key.
The following message is shown on the display: Please inspect the cabin and
check the steam inlet. Nothing must be positioned on the steam inlet.
Message will disappear automatically.
Following view is displayed if no valid start time is programmed. In that case, pro-
gramme a start time first.








Press (basic settings)
-key.
key. The lamp next to the key must light up.
"Basic settings" menu
Not available with FCU2000 and
FCU3000
Not available with FCU2000 and
FCU3000
29