Select Program (Only For Fcu4Xxx) - Fasel Elektronik FCU2000 Series Operating Manual

10. Press the
11. Select the next line with the
12. You can set the stop time (end) and the duration similar to the start time. If you
13. Press the
14. Select the next line with the
15. Select mode. Cursor flashes.
16. Press the
17. Select the next line with the
18. Select program no. Digit flashes.
19. Press the
20. Exit the menu using the
6.1.4

Select program (only for FCU4xxx)

In this menu you can select 1 of 8 programs.
1. Press key "basic settings". The lamp next to the key must light.
2. Press
Abb. 21: View "select program" (example)
3. Press
4. Select desired program with the keys
5. Confirm with key
Operating manual Steam bath control Series FCU2000/FCU3000/FCU4000 B_FCUxxxx-Steam_EN / Version V 2.03
key. The selection is saved.
change the end time, the duration changes automatically.
key. The selection is saved.
Select the mode with the
key. The selection is saved.
Press the key: Reduce value.
Press the key: Increase value.
key. The selection is saved.
Note!
For each mode there exist 8 programs which are freely adjustable. .
The program numbers are shown on the display. (These 8 freely ad-
justable programs may be locked by the service engineer.)
-key until the following view is shown:







-key
or key.
or key.
or key.
or key.
key.
Not available with FCU2000 and
or.
"Basic settings" menu
FCU3000
31