Turn Steam Bath Control On And Off; Turn Steam Bath Control On; Turn Steam Bath Control Off - Fasel Elektronik FCU2000 Series Operating Manual

Operation
5.2

Turn steam bath control on and off

5.2.1

Turn steam bath control on

Ensure that the steam inlet, the surrounding area and the sensors are free of objects.
1.
2.
3.
5.2.2

Turn steam bath control off

The "Steam bath" mode is selected. The corresponding green lamp lights up.
1.
2.
16 Operating manual Steam bath control Series FCU2000/FCU3000/FCU4000_ B_FCUxxxx-Steam_EN / Version V 2.03
NOTE!
The temperature values displayed on additional thermometers in the
cabin can deviate from the displayed values on the control. This could
be due to the following reasons:
Depending on the cabin, the temperature differences from the floor to
the ceiling can be considerably.
Instruments with indicator needles react slower than electrical measur-
ing and display systems used for the control.
Turn on the steam bath control using the "Control unit ON" key. → See page 14,
Fig. 2
The set point temperature, the aroma settings and the heating time are displayed.
The green lamp of the "Steam bath" key flashes.
Start mode according to chapter.5.2.3.
PLEASE NOTE!
The electronic components can be damaged by repeated improper
turning off!
Therefore:
– Turn off the steam bath control as described.
PLEASE NOTE!
Cabin damage for e.g. mould growth due to premature stopping of
the fan after-run time!
In order to remove the moisture in the steam bath room, you can set a
fan after-run time in the basic setting menu after completion of the
steam bath programme. This ensures that the fan is running for the ex-
tra time you have set after the steam bath operation. This function is
used to avoid cabin damage such as mould growth.
Therefore:
– Do not stop the fan after-run time prematurely.
Press the key of the „steam bath" mode. The green lamp next to the key flashes.
The green lamp of the „steam bath" mode flashes. Turn off the steam bath control
using the "Control unit OFF" key. → See page 10, Fig. 2