Light Settings (Only For Menu "Pro") - Fasel Elektronik FCU2000 Series Operating Manual

6.1.7

Light settings (only for menu "Pro")

In this menu you can set the time, when the light should go on and how long it should
stay on after the end of a mode.
1.
2.
Fig. 24: "Light settings" view (example)
3.
4.
Fig. 25: "Light settings – change mode" view (example)
5.
6.
7.
8.
9.
10. Press the
11. Option "light ON after heat-up phase" is enabled. Cursor flashes on the selected
Operating manual Steam bath control Series FCU2000/FCU3000/FCU4000 B_FCUxxxx-Steam_EN / Version V 2.03
Press (basic settings)
Press the key until you see the following view:







Press the key.
Following view is displayed:








Select one of the following lines with the
– Light ON at start
– Light ON if mode ready
– Falling delay time x min
Note!
Only the option "light ON at start" or "light ON if mode ready" can be selected.
Press the key. Selected line is enabled.
Option "light ON upon starting" is enabled. Cursor flashes on the selected line.
Press the key. Check mark is set (option selected).
Press the key: Check mark is deleted (option not selected).
Press the key. The selection is saved.
Exit the menu using the
key. The selected line is enabled.
line.
key. The lamp next to the key must light up.




or



key or select the next line with the
"Basic settings" menu
key:
(→ point 7)
(→ point 11)
(→ point 15)
or key.


33