Select Or Start The Mode; Adjust "Steam Bath" Mode - Fasel Elektronik FCU2000 Series Operating Manual

5.2.3

Select or start the mode

Mode
1.
select
2.
3.
Key
Table: 5 Mode control keys
5.3

Adjust "Steam bath" mode

The control unit is turned on.
1.
2.
Fig. 4: "Steam bath" view (example)
3.
4.
5.
6.
7.
Operating manual Steam bath control Series FCU2000/FCU3000/FCU4000 B_FCUxxxx-Steam_EN / Version V 2.03
Turn on steam bath control according to chapter 5.2.1.
The green lamp of the "Steam bath" mode flashes.
Press the key for the "Steam bath" mode. The lamp flashes. Mode was started.
NOTE!
There are two menu navigations available for the control unit. All the
menus are displayed only in the "Professional" menu. These menus are
indicated accordingly in this chapter. If these menus are not displayed,
your control has been set to the "Small" menu
Furthermore, the control unit can be equipped with extension boards
like for e.g. for colour light. This requires additional menus, which are
indicated accordingly in this chapter. For information about the fittings of
your steam bath control, please contact the installer or the dealer of
your steam bath system.
The lamp next to the
Following view is displayed:





Press the key.
The symbol (adjust the temperature) lights up. → See page 18, chapter 5.4.
Press the key.

The symbol (Adjust aroma) lights up. → See page 21, chapter 5.5.1.
Press the key
Description
Steam bath mode

"Steam bath" key must flash or light up.
See also page 39.
→


Operation

17