Creating Netmap Rules - Siemens SCALANCE M-800 Series Getting Started

For "Operation" select the following and click "Set Values"
Operation
The M876 establishes the VPN tunnel to the M816. If the VPN tunnel is established, the
LED is lit green on the devices.
6.3.2

Creating NETMAP rules

Requirement
● The VPN connection M876_to_M816_2 is configured, see Creating a VPN connection
(Page 217).
● The NETMAP rules for the local network (Page 214)have been created.
● The NETMAP rules for the remote network (Page 209)have been created.
Procedure
1. Click on "Layer 3" > "NAT" in the navigation area and on the "NETMAP" tab in the content
area.
2. Specify the NETMAP rule
3. Click "Create". A new row is created in the table with the settings.
4. Click "Set Values".
SCALANCE M-800 Getting Started
Getting Started, 06/2015, C79000-G8976-C337-04
On the M816
wait
(Responder)
Type
Source Interface
Destination Interface
Source IP Subnet
Destination IP Subnet
Translated Source IP Subnet
6.3 NETMAP for the local and remote network
On the M876
start
(Initiator)
for the outgoing queries with the following settings:
Source
vlan1
IPSec M876_to_M816_2
192.168.20.0/24
192.168.100.0/16
192.168.200.0/24
NETMAP with SCALANCE M-800
219