Configure Communications Relations - Siemens SCALANCE M-800 Series Getting Started

VPN tunnel between SCALANCE M87x and SINEMA RC Server
5.3 Configure a remote connection on the SINEMA RC Server
5.3.3

Configure communications relations

So that participant groups can communicate with each other, communication relations are
necessary. A communication relation can be created for every direction.
For this sample configuration, the following communication relations are created:
from group
Service
Station -1
In this configuration example, communication is only from the group "Station 1" to the group
"Station 2". In the opposite direction, no communication is possible. For the communication
from the group "Station 2" to the group "Station 1" another communication relation is
necessary.
The group "Service" can also communicate with the groups "Station 1" and "Station 2" but
not the other way round.
Procedure
1. In the navigation area, click "Remote connections" > "Participant groups". The participant
groups that have already been created are listed in the content area.
2. For "Station 1", click the symbol
is opened.
3. Enable "Station 2" and click on "Save".
4. Click "Exit dialog".
5. For "Service", click the symbol
is opened.
6. Enable "Station 1" and "Station 2". Click "Save".
7. Click "Exit dialog".
192
to the destination group
Station -1
Station-2
Station-2
in the "Actions" column. The page "Destination group"
in the "Actions" column. The page "Destination group"
Getting Started, 06/2015, C79000-G8976-C337-04
SCALANCE M-800 Getting Started