Digital Equipment DEC 3000 Series Service Information page 350

LED Codes and Status/Error Messages
14–28
? T-ERR-NI - Rx err
T-ERR-NI - Err = (error code) CSR0 = (csr0) rx_addr = (rx address)
T-ERR-NI - rx_desc1 = (rx data1) rx_desc2 = (rx data2)
? T-ERR-NI - Net Addr ROM test - group err
T-ERR-NI - Err = (error code) na_base = (base addr) na_data1 = (data1)
T-ERR-NI - na_data2 = (data2) cksum = (checksum)
? T-ERR-NI - Net Addr ROM test - test patt err
T-ERR-NI - Err = (error code) patt1 = (pattern1) patt2 = (pattern2)
? T-ERR-NI - LANCE Reg test - data miscompare
T-ERR-NI - Err = (error code) Addr = (address)
Exp = (exp data)
? T-ERR-NI - Int Lpbk and DMA test - Pkt err
? T-ERR-NI - Int test - Pkt err
? T-ERR-NI - CRC test - Pkt err
? T-ERR-NI - Addr Filter test - Pkt err
? T-ERR-NI - Ext Lpbk test - Pkt err
T-ERR-NI - Err = (error code) CSR0 = (csr0)
T-ERR-NI - pkt_len = (packet length) pkt_pattern = (packet pattern)
pkt_crc = (packet crc)
? T-ERR-NI - Int test - int err
T-ERR-NI - Err = (error code) IR = (ir)
T-ERR-NI - SIR = (sir) SIM = (sim)
? T-ERR-NI - Ext Lpbk test - Pkt err
T-ERR-NI - Err = (error code)
Message Meaning
Error code from NI error codes section.
error code
Contents of LANCE CSR0.
csr0
TURBOchannel interrupt register contents at
ir
error.
Physical DMA address.
dma address
Physical DMA address of the current transmit
tx address
descriptor.
First four bytes of the transmit descriptor.
tx data1
Second four bytes of the transmit descriptor.
tx data2
Physical DMA address of the current receive
rx address
descriptor.
First four bytes of the receive descriptor.
rx data1
Second four bytes of the receive descriptor.
rx data2
Initialization block mode.
mode
Upper longword of the logical address filter.
ladrf0
Lower longword of the logical address filter.
ladrf1
TURBOchannel interrupt register contents at
ir
time of error.
Physical DMA address of the initialization
init address
block.
Base address of the network address ROM.
base addr
First four bytes of the network address ROM.
data1
Next two bytes or network address and two
data2
byte check.
Act = (actual data)