Digital Equipment DEC 3000 Series Service Information page 346

LED Codes and Status/Error Messages
14–24
? T-ERR-SCSI (bus) - Min Dev test - start unit
? T-ERR-SCSI (bus) - Min Dev test - test unit ready
? T-ERR-SCSI (bus) - Min Dev test - rewind
? T-ERR-SCSI (bus) - Min Dev test - mode select
? T-ERR-SCSI (bus) - Min Dev test - read
? T-ERR-SCSI (bus) - Min Dev test - send diagnostic
T-ERR-SCSI (bus) - id = (device id) lun = (logical unit number)
info = (informational value)
T-ERR-SCSI (bus) - actcmd = (actual command)
curcmd = (current command)
status = (status) int = (interrupt)
T-ERR-SCSI (bus) - IR = (ir) CIR = (cir) IME = (ime)
T-ERR-SCSI (bus) - snskey = (sense key) extfru = (extended fru info)
? T-ERR-SCSI (bus) - Min Dev test - wrong num bytes
? T-ERR-SCSI (bus) - Min Dev test - data miscompare
T-ERR-SCSI (bus) - id = (device id) lun (logical unit number)
Message Meaning
Sparse address of failing location.
address
Expected data.
exp data
Actual data.
actual data
A or B.
bus
SCSI ID number.
device id
Logical unit number of device.
logical unit
number
Informational value from following table.
info
Original command that was sent to SCSI bus.
actcmd
Actual command that failed.
curcmd
SCSI controller Status register contents at
status
time of error.
SCSI controller Interrupt register contents at
interrupt
time of error.
TURBOchannel Interrupt register contents at
ir
time of error.
DUAL SCSI ASIC Control Interrupt Register
cir
contents at time of error.
DUAL SCSI ASIC Interrupt Mask Enable
ime
register contents at error.
Virtual address of data.
data addr
Map register address.
map reg adr
The next two values are printed out when a request sense
command is executed.
Note