Using the Console and Utilities Commands
Command
$MC NCP
NCP> SHOW KNOWN
CIRCUITS
NCP> CONNECT VIA circuit
SERVICE PASSWORD xxxx
PHYSICAL ADDRESS 08-00-
2B-XX-XX-XX
>>>Login
Password
>>> CTRL/D
NCP> EXIT
$LO
13–46
MOP, TRIGGER
Once the system is set up, perform the following steps from the
other operating system to connect to the console:
Log into the user account (no special privileges are required)
1.
Enter the following commands:
2.
$ MC NCP
NCP> SHOW KNOWN CIRCUITS
NCP> CONNECT VIA circuit SERVICE PASSWORD xxxx
PHYSICAL ADDRESS 08-00-2B-XX-XX-XX
>>>
>>> CTRL/D
NCP> EXIT
$ LO
Meaning
Enters the Network Control Program (NCP).
Shows available circuits to which you can connect.
Connects to the console.
Performs console functions.
System response to LOGIN command. You must enter
the correct password to gain access to the system.
Disconnects console.
Exits NCP.
Logs off the system.
Do not run the memory diagnostic. It causes the console to
hang and you will have to power off the system.
Note