Digital Equipment DEC 3000 Series Service Information page 348

LED Codes and Status/Error Messages
14–26
Information Description
27 Should not be in data in phase.
28 Problem with a device trying to reconnect.
29 Unexpected disconnect message received.
2A Device not seen before trying to reconnect.
2B Bad identify message received on reconnection.
2C Out of retries for this command.
2D Too many bytes sent in data out phase.
2E Too many bytes received in data in phase.
2F SCSI Parity error.
30 SCSI Map error.
31 SCSI Bit in TURBOchannel interrupt register is
not set.
32 SCSI Bit in TURBOchannel interrupt register is
set.
33 SCSI Bit in control interrupt register is not set.
34 SCSI Bit in control interrupt register is set.
35 SCSI Bit in control interrupt register will not
clear.
36 Control Interrupt register contents different from
expected.
37 Control Status register contents different from
expected.
50 Wrong device type. Device is not of type specified.
51 Not enough data returned in mode sense
command.
52 Byte count specified for read or write is too small.
53 Boot block checksum error.
54 Boot block flags is not zero.
55 Boot block count is zero.
56 Device is too small for specified read or write.
57 Device block size is not valid.
58 Prom$ routine error.
59 Error parsing boot string.
90 SCSI Bus specified is not valid.
91 Utility specified is not valid.
92 Device number specified is not valid.
93 LUN specified is not valid.
94 Wrong number of parameters for utility .
95 Device number specified is the same as the host.
96 Wrong mode of operation.
97 Not enough data returned from device.
98 Device is not a disk.
99 Device is not a tape.
9A Device is not removable.
9B Device is removable.
9C Media is write protected.
9D Device is not ready.
9E Data read is incorrect.
9F LUN is illegal.
A0 Problem building format page.
A1 Problem building flexible page.