Digital Display Information; Power Assembly; Requirements For Connecting Additional Equipment - Abbott CentriMag Operation Manual

6.8 Digital Display Information

The Console's digital display provides messages and information on System settings,
Console configuration and alarms/alerts. Table 7 shows System alarm and alerts in the
order of priority:
Table 7: Front Panel Display – Alarm/Alert Messages in Order of Priority
ALARMS
POWER ON TEST FAIL
SYSTEM FAULT
MOTOR STOPPED
MOTOR DISCONNECTED
PUMP NOT INSERTED
MOTOR ALARM

6.9 Power Assembly

The Power Assembly is located on the Console's back panel and contains the AC Power
Connection, Monitor Connection and LEMO Motor Connection.

6.10 Requirements for Connecting Additional Equipment

Additional equipment connected to medical electrical equipment must comply with the
respective IEC or ISO standards (e.g. IEC 60950-1 for data processing equipment and
IEC 60601-1 for medical equipment). Anyone connecting additional equipment to medical
electrical equipment configures a medical system and is therefore responsible that the
system complies with the requirements for medical electrical systems. Local laws take
priority over the above mentioned requirements. If in doubt, consult your local
representative or the technical service department.
TM
CentriMag Circulatory Support System Operation Manual (US)
© 2019 Abbott – Document No PL-0047, Rev 11 (December 2019)
ALERTS
SET PUMP SPEED NOT REACHED
BATTERY MODULE FAIL
BATTERY BELOW MINIMUM
FLOW PROBE DISCONNECTED
SYSTEM ALERT
FLOW SIGNAL INTERRUPTED
FLOW BELOW MINIMUM
FLOW ABOVE MAXIMUM
PRESSURE 1 DISCONNECTED
PRESSURE 2 DISCONNECTED
PRESSURE SYSTEM FAIL
PRESSURE 1 BELOW MINIMUM
PRESSURE 2 BELOW MINIMUM
PRESSURE 1 ABOVE MAXIMUM
PRESSURE 2 ABOVE MAXIMUM
MOTOR OVER TEMP
BATTERY CHARGER FAIL
BATTERY MAINTENANCE REQUIRED
LOW BATTERY
ON BATTERY
Page 49 of 126