Monitor Mounting - Abbott CentriMag Operation Manual

Figure 21: Mounting of Two Consoles onto System Cart
WARNING
Only use the Standoff Distance Holder and the Standoff provided by the
supplier. Use of any other component may result in a sudden Motor stop.

7.3 Monitor Mounting

7.3.1 If the Console is intended to be used with the Monitor, the Monitor must be
securely fixed to a solid object. This can be achieved with the Monitor Arm
provided by Abbott Medical and Ergotron. The Monitor Arm can be mounted
either on the edge of a horizontal or vertical solid surface or on a vertical
pole. For instructions on how to set-up the Monitor Arm refer also to the
manual provided by Ergotron. Steps required to set-up the Monitor Arm:
1. Mount the Monitor Arm Clamp on the adapter plate: Figure 22 illustrates the two
possibilities for mounting the clamp on the adapter plate. If the Monitor Arm is to be
mounted on the edge of a vertical surface or a vertical pole, the clamp has to be
mounted as shown in part A of Figure 22. If the Monitor Arm is to be mounted on the
edge of a horizontal surface, the clamp has to be mounted as shown in part B of
Figure 22. Make sure that the oval end of the adapter plate is on the screw side of the
clamp in the latter case.
TM
CentriMag Circulatory Support System Operation Manual (US)
© 2019 Abbott – Document No PL-0047, Rev 11 (December 2019)
Page 53 of 126