Setting Up The System; Unpacking - Abbott CentriMag Operation Manual

7 SETTING UP THE SYSTEM

This section describes how to unpack the Console, connect the power cord, the Motor,
and the Flow Probe and how to mount, power up and operate the System including using
the optional elements listed in Table 2. The Console carries the following Factory
5
Power-Up defaults for each specified operating parameter:
Table 8: Console Factory & Power-Up Default Values
OPERATING PARAMETER
Minimum Flow Alert
Maximum Flow Alert
Flow Display range
Pressure Subsystem
Pressure limits
Language
RPM Increment
Flow Limit Sensitivity
Recorder Speed

7.1 Unpacking

1. Remove the Console, AC Power Cord, and Flow Probe from the Console's shipping
container.
2. Remove the Motor from its shipping box.
3. Remove the Monitor from its shipping box
4
Factory Default: pre-selected operating parameter of a 2
from the manufacturer.
5
Power-Up Default: 2
are stored in the Console's permanent memory and recalled each time the Console is powered up.
6
Note: If the probe detects forward flow of more than 10 LPM then it will display as "^^.^^ LPM".
7
Last state: the value/state carried from the last operational use of the 2
TM
CentriMag Circulatory Support System Operation Manual (US)
© 2019 Abbott – Document No PL-0047, Rev 11 (December 2019)
nd
Generation CentriMag Console operating parameter after the 1
FACTORY
4
DEFAULT
0.0 LPM
8.0 LPM
6
-2.0 – 10.0 LPM
Inactive
-30mmHg / +200mmHg -30mmHg / +200mmHg
English
100
Normal
2 minutes
nd
Generation CentriMag Console as it is shipped
nd
Generation CentriMag Console.
4
and
POWER-UP
5
DEFAULT
0.0 LPM
8.0 LPM
-2.0 – 10.0 LPM
7
Last state
7
Last state
7
Last state
7
Last state
2 minutes
st
use. These values
Page 50 of 126