Preparing To Upgrade To Xcp 1050 Or Later; Upgrading From Xcp 104X To Xcp 1050 Or Later - Sun Microsystems SPARC Enterprise M5000 Product Notes

Preparing to Upgrade to XCP 1050 or Later

The following step must be completed prior to upgrading:
●
Delete any accounts named admin.
Use the showuser -lu command to list all XSCF accounts. Any accounts named
admin must be deleted prior to upgrading to XCP 1050. This account name is
reserved in XCP 1050 and higher. Use the deleteuser command to delete the
account.
Note – For more information on admin accounts, see
Documentation Updates" on page

Upgrading From XCP 104x to XCP 1050 or Later

Note – LAN connections are disconnected when the XSCF resets. Use the XSCF
serial connection to simplify the XCP upgrade procedure.
1. Log in to the XSCF on an account with platform administrative privileges.
2. Verify that there are no faulted or deconfigured components by using the
showstatus command.
XSCF> showstatus
The showstatus prompt will return if there are no failures found in the System
Initialization. If anything is listed, contact your authorized service representative
before proceeding.
3. Power off all domains.
poweroff -a
XSCF>
4. Confirm that all domains are stopped:
XSCF> showlogs power
5. Move the key position on the operator panel from Locked to Service.
30.
Sun SPARC Enterprise M4000/M5000 Servers Product Notes
TABLE 9, "Software
25