Installing The Extra Brackets (Optional) - Sun Microsystems SPARC Enterprise M5000 Product Notes

Installing the Extra Brackets (Optional)

The following information belongs in the Sun SPARC Enterprise Equipment Rack
Mounting Guide.
If additional attachment points are required to route the cables, you can install the
extra brackets that are in the bracket kit. The bracket kit contains the following:
Two (2) brackets
■
Four (4) m5 screws
■
Four (4) cage nuts
■
14 velcro strips
■
These brackets can be used with or without the CMA for the Sun SPARC Enterprise
M4000/M5000 servers.
1. Extend the rack stabilizer.
2. Slide the server out of the rack several inches for access to the rear of the Sun
Rack.
3. Position the cage nuts behind the threaded ears of the Sun Rack and insert the
two (2) screws through the bracket and rack ear
Brackets should be positioned near the top level of the server or slightly below it.
Note – Brackets can be installed one per side, one only (right or left side), or two on
one side, as desired for convenience in cable management.
(FIGURE
Sun SPARC Enterprise M4000/M5000 Servers Product Notes
5).
9