Table of Contents
Advertisement
FAN INSTALLATION
Installer: Please record unit serial number here before installing blower.
Serial No.______________________________
1. Align the fan support with the offset clip
on the bottom of the ashlip.
2. Slide the supports into the clips. The tension
holding the clips in place may be adjusted by
increasing or decreasing the offset spacing of
the clips.
3. Ensure that the power cord is not in contact
with any hot stove surfaces.
NOTE: DO NOT ROUTE POWER CORD
UNDER OR IN FRONT OF UNIT.
Neutral
Live
120V AC
60 Hz
Fan Thermodisc
(normally open)
4. Push the Regency logo plate into the two holes
in the front bottom left corner of the fan.
Do not turn fan ON until your insert has
reached operating temperature or at least
30 minutes after starting fire.
Important:
The blower to this appliance must be turned
off anytime the fuel door is opened. Prior to
turning the blower back on, ensure there are
no embers near the blower which may have
fallen onto the hearth when the fuel door was
opened. Once the fuel door is closed, the blower
may be turned back on.
Manual/
Green
Ground
Auto
Switch
Black
Black
Blower/Fan Wiring Diagram
CAUTION: Label all wires prior
to disconnection when servic-
ing controls. Wiring errors can
cause improper and dangerous
operation.
Electrical Grounding Instructions
This appliance is equipped with a
three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
Fan
Switch
Black
Fan
Fan
Regency I2500-1 Wood Fireplace Insert
installation
WARNING:
Ground
|
|
15
15
Advertisement
Table of Contents
