Installing An Optional Wall Switch (Not Offered By Regency) Or Thermostat (Part # 910-407 Or 910-404/P) - Regency Grandview G600C Owners & Installation Manual

Installing an Optional Wall Switch (Not Offered by Regency) or Thermostat (Part # 910-407 or
910-404/P)
A wall-mounted On/Off switch or Thermostat may be used to operate the
on/off functionality of the main burner. External electricity is only required to
operate the convection fan, and is not required to operate the fireplace. The
millivolt gas control system uses the pilot flame to generate enough electric-
ity to operate the main burner. To install a wall switch or thermostat, follow
the directions below.
1. Remove safety screen, glass door and bottom cover panel (see manual
for details).
2. Locate the black wire running from the valve to the unit on/off switch.
Unclip the wire holder clip and remove the black wire from the clip.
3. Break the connection between the inline wire connectors on the black
wire. The wall switch or thermostat wiring will run to these two connec-
tors.
4. Route the wiring for your wall switch or thermostat from the wire con-
nectors through the hole on the right side of the unit, using the supplied
black plastic strain relief to secure the wiring as it passes through the
unit.
5. Install the wall mounted on/off switch or thermostat as per local electrical
code requirements.
Refer to the manual for the full wiring diagram.
Grandview
installation
G600C Gas Fireplace | 79
®