Function Keys For Remote Maintenance Access; Configuring - Mitel Aastra 470 System Manual

5. 4. 3

Function keys for remote maintenance access

On system phones (with the exception of Office 10) the function code for enabling/
barring remote maintenance access can be stored under a function key, provided
the user has the appropriate authorization.
The relevant LED lights up if remote maintenance access is enabled once or perma-
nently.
The relevant LED goes off as soon as remote maintenance access is denied again,
either automatically or manually, using the function code, WebAdmin or the sys-
tem assistant on Office 45.
5. 5

Configuring

The configuration steps are based on the information determined during the plan-
ning and, where applicable, the installation.
Whenever possible, use the planning and ordering software Aastra Plan, to set up
your communication system. Aastra Plan can be operated online after logging in at
Aastra Connect http://connect.aastra.com. Aastra Plan not only calculates the re-
quired hardware – it also lists the required licences for planned operation.
See also:
If you are setting up an Aastra 400 communication system for the first
time, we recommend to you the Getting-started package (see
steps...", page
Setup wizard
The WebAdmin setup wizard takes you step by step through the setup of a basic
configuration and is suitable for initial communication server setup. The setup wiz-
ard is automatically called up when a new communication server is installed. Log-
ging on as administrator in WebAdmin (expert or default mode) allows you to also
start the setup wizard directly from the WebAdmin navigation tree.
The setup wizard comprises the following steps:
1. Activating licences
2. Setting up the IP addressing
3. Configuring media resources
4. Setting up the numbering plan
5. Setting up SIP providers
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014
35).
Configuration
"First
191