Fitting Application Card Cpu2 - Mitel Aastra 470 System Manual

Installation
4. 5. 2

Fitting application card CPU2

The application card is wider than an interface card and can only be fitted to slot 2
(see Fig. 26).
To fit an application card, proceed as follows:
Warning
Be sure to observe the
1. Unscrew the screw on the larger dummy cover in slot 2 and remove the cover by
pulling the screw.
2. Remove the plastic cover of the narrow dummy cover in slot 2. To do so insert a
screwdriver at an angle from below to release the snap-in mechanism on the
plastic cover.
3. Unscrew the screw on the narrow dummy cover and remove the cover by pull-
ing the screw.
4. Carefully slide the application card into the shaft of slot 2 and gently press the
card as far as it goes into the connection on the backplane.
5. Use the screw to secure the card in its slot.
6. Connect the cables of any assigned interfaces on the front panel of the applica-
tions card.
7. Start up the applications server by pressing the On/Off button on the applica-
tions card.
See also:
For more information about installing, configuring and upgrading the
software of the application card, see the CPU2-S application card installa-
tion manual.
106
"Safety regulations", page 92.
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014