Operating State Of The Aastra Dect Radio Units - Mitel Aastra 470 System Manual

6. 6. 2. 4

Operating state of the Aastra DECT radio units

Each radio unit is equipped with 3 LEDs. The operating state the radio units is indi-
cated by different colours and flashing sequences in cycles of 1 s, specifically by
one of the two outer LEDs on the SB-4+ and by both outer LEDs on the SB-8 / SB-
8ANT (separately for each DSI bus). Each character (G, R or -) corresponds to 1/8 of a
second.
Example:
During the synchronization phase GGGGRRRR the LED flashes periodically.
1/2 second green, 1/2 second red.
Tab. 100 Flashing sequences of the status LED on the DECT radio unit
State Cycle
No flashing – – – – – – – –
Red
R R R R R R R
– – – – – – –
R
Green / red
G R R R R R R R
G R G R G R G R
G G G G G R R R
G G G G G G G R
G G G G G R G R
Green
– – – – – – –
G
G G G G
G G G G G G G
1)
This operating state appears in the following situations:
- During a configuration data upload
- After a system first-start
- If in WebAdmin in the
- If no location area is assigned to a radio unit - (This may happen after adding a radio unit to a system with
several Location Areas, which is the case when a radio unit has already been set in a Location Area unequal
0). In this case the added radio unit has to be manually allocated to the selected Location Area.)
An orange status LED indicates that DECT signalling is active, i.e. DECT sequences
are currently being transmitted between the cordless phone and the radio unit. Ex-
amples:
• With each keystroke on the cordless phone the LED briefly lights up orange.
• During a cordless phone firmware download the orange LED remains lit until the
download is completed.
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014
Meaning
LED switched off / software not running / RU not connected
Error:
– DSI bus not in order
Power supply error or DSI line too long
Startup process:
DSI ok
Software is uploaded
Synchronizing
DECT is being started
HF Power Down / DECT System Status Passive
Normal operation (requirement: LED not switched off):
All B channels available
– – – – 1 to 3 B channels busy
– 3 B channels busy
DECT ( =sa) view the parameter
Operation and Maintenance
DECT system status is set to
1)
Passive
251