New Card With Fewer Ports; New Card With More Ports - Mitel Aastra 470 System Manual

Operation and Maintenance
6. 3. 3. 2

New card with fewer ports

A card is replaced by a similar card with fewer ports.
Procedure:
Change the card and put the system into operation again. Similar procedure as de-
scribed in "Replacing a defective interface card", page
The following data is deleted:
• The system and terminal configuration data of the terminals on the terminalin-
terfaces that are no longer present in the new configuration.
• The system configuration data of the network interfaces that are no longer pres-
ent in the new configuration.
Tab. 85 Example: Reducing the number of terminal or network interfaces
16DSI  8DSI
8BRI  4BRI
Note:
If the terminal configuration data of system phones is deleted following
the reconfiguration of a card, a warning message will appear beforehand
to give you the possibility of cancelling the process. However, this is pos-
sible only if the configuration data of the original card was not already
deleted beforehand.
6. 3. 3. 3

New card with more ports

A card is replaced by a similar card with more ports.
Procedure:
1. Change the card and put the system into operation again. Similar procedure as
described in "Replacing a defective interface card", page
2. In the WebAdmin view
3. Configure new ports.
The system configuration data (User No., User configuration, etc.) of the terminals
on the new ports is created as new data (default values).
Tab. 86 Example: Expanding the number of terminal or network interfaces
8DSI  16DSI
4BRI  8BRI
210
The configuration data of terminal interfaces 9...16 are deleted.
The configuration data of network interfaces 5...8 are deleted.
Cards and modules
The configuration data of terminal interfaces 9...16 is created as new data.
The configuration data of network interfaces 5...8 is created as new data.
209.
209.
( =4g) Confirm the new cards.
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014