Replacing The Flash Card - Mitel Aastra 470 System Manual

Operation and Maintenance
6. 3. 5. 2

Replacing the Flash Card

The Flash card is fitted to the call manager card and available as a spare part.
To replace a defective Flash card, proceed as follows:
Warning
Be sure to observe the
1. Carry out preparations (see
2. Unscrew the screw on the Call Manager card and remove the card by pulling the
fastening screw.
3. Remove the defective Flash card by pulling it out on the side.
4. Fit the new Flash card and gently press the card as far as it will go into the plug-
in connection.
5. Carefully push back the call manager card into the shaft and gently press the
card as far as it goes into the connection on the backplane.
6. Secure the Call Manager card back into its slot with the screw.
7. Restart the call manager by pressing the On/Off button on the call manager
card.
Notes:
– The Flash cards are expected to meet high demands in terms of data
security (read and write cycles). That is why only original Flash cards
are to be used.
– Flash cards that are ordered as spare parts do not contain any soft-
ware. In this case an Emergency Upload has to be carried out (see
"Loading new or older system software with System Search",
page 203).
216
"Safety regulations", page
"Preparations", page
92.
207).
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014