Standard Glass - Steelcase RoomWizard Installation Instructions Manual

Standard Glass

1. Temporarily locate the glass mount bracket onto the
glass. The glass mounting bracket should be centered
52" (132cm) from the floor.
2. Thoroughly clean an area at least as large as the
mounting bracket using the alcohol wipe provided.
Allow to completely dry (approximately 20 seconds)
before attaching mount bracket. Removal of any vinyl
applique is required, vinyl must be cut to a 3-3/8" x 7-
1/4" (8.5cm x 18.5cm) rectangle. Glass must be clean,
free of any residue and dry from any previous
application used.
2. Route the PoE cable through the glass mounting
bracket.
3. Peel the backing film from the adhesive mounting
strips on the back of the glass mounting bracket.
Ensuring the glass mounting bracket is level, press the
glass mounting bracket onto glass. Hold even
pressure for at least 15 seconds.
4. Slide PoE cable cover over PoE cable and position
between the glass mounting bracket and the glass
frame. The PoE cable cover should extend no more
than a ½" (12mm) into the mount.
5. Plug the PoE cable into the back of the RoomWizard.
6. Attach the RoomWizard to the glass mount bracket.
7. Peel or cut the tabs on protective cover and slide to
remove the protective cover.
RoomWizard
52"
(132cm)
TO FLOOR
PoE CABLE
COVER
4
6
Peel or cut the tabs on the protective cover.
Mounting Kits
©
Installation Instructions
GLASS
MOUNT
BRACKET
REMOVE BACKING FILM
FROM ADHESIVE STRIP
5
7
Page 6 of 20
PoE CABLE