Glass Tilt Bracket Kit - Steelcase RoomWizard Installation Instructions Manual

Glass Tilt Bracket
1. Temporarily locate the glass tilt bracket onto glass wall.
The glass tilt bracket should be centered 52" (132cm)
from the floor to the center of the PoE cable hole.
2. Thoroughly clean an area at least as large as the glass tilt
bracket using the alcohol wipe provided. Allow to
completely dry (approximately 20 seconds) before
attaching mount bracket. Removal of any vinyl applique is
required, vinyl must be cut to a slightly larger than the
glass tilt bracket). Glass must be clean, free of any residue
and dry from any previous application used.
3. Peel the adhesive backing film from the adhesive
mounting strips on the back of the glass tilt bracket.
Ensuring the glass tilt bracket is level, press the glass tilt
bracket onto glass. Hold pressure for at least 15 seconds.
4. Slide the cable cover over the PoE cable and route both
through the glass tilt bracket and the wall mount bracket.
REMOVE ADHESIVE
BACKING FILM
RoomWizard
GLASS TILT BRACKET
50-3/8"
(128cm)
to floor
4
MOUNT
Mounting Kits
©
Installation Instructions
52"
(132cm)
TO FLOOR
PoE CABLE
AND
CABLE
COVER
Page 17 of 20