Media:scape - Steelcase RoomWizard Installation Instructions Manual

media:scape (

media:scape or other structural
members)
1. Temporarily locate the wall mount bracket onto
shroud. The wall mount bracket should be centered
52" (132cm) from the floor. Ensuring mount bracket is
½
level, mark (1) " or 5/8" hole for PoE cable and (4)
3/16" (5mm) for mounting hardware.
Notice
Confirm there are no items that could
i
pose an interference on the rear side of
the media:scape shroud.
2. Remove wall mount bracket from shroud and drill four
(4) 3/16" (5mm) holes for mounting hardware and
½
one (1) (12mm) or 5/8" (16mm) hole for the PoE
"
cable.
3. Route the PoE cable through the hole in the
media:scape shroud and wall mount bracket.
See Table 1 for correct exposed length.
4. Replace the wall mounting bracket onto the shroud
and using a #2 Phillips screwdriver, install using the
four (4) screws and four (4) washers and four (4) nuts.
Ensure wall mount bracket is level before final
tightening
5. Plug the PoE cable into the back of the RoomWizard.
1
2
½
5/8" (16mm)
DRILL BIT FOR
PoE CABLE
52"
(132cm)
to floor
5
RoomWizard Mounting Kits
©
Installation Instructions
" (12mm) or
4
Page 13 of 20