Wall Tilt Bracket
1. Temporarily locate the wall mount bracket onto the wall.
The wall mounting bracket should be centered 52"
(132cm) from the floor. Ensuring it's level, mark (1)
5/8" hole for PoE cable and (4) 3/16" (5mm) for wall
anchors.
2. Remove mount bracket from wall and drill four (4) 3/16"
(5mm) holes for wall anchors and one (1)
5/8" (16mm) hole for the PoE cable. Note: if there is a
metal stud use a #32 (3mm) drill to use with the supplied
screws.
3. Screw the wall anchors into the wall using a #2 Phillips
screwdriver. Be sure not to overtighten. Just tighten until
the wall anchor flanges are completely against the wall
surface.
3/16
" (5mm) for Wall Anchors
#32 (3mm) Sheet Metal Screws
½
" (12mm) or 5/8" (16mm)
DRILL BIT FOR PoE CABLE
½
" or
½
(12mm) or
"
or
RoomWizard
Wall Anchor
52"
(132cm)
to floor
Mounting Kits
©
Installation Instructions
52"
(132cm)
to floor
3
Page 15 of 20