Otto Bock 17AD100 10 Instructions For Use Manual page 39

10) Set the mounting adapter onto the support element (item 9) and loosen it
from the basic piece with a Torx wrench. INFORMATION: Inspect the
support element semiannually in the course of maintenance and
replace it with a new support element after one year.
11) Use a Torx wrench to loosen the stop pin (item 10) from the spring plun­
ger and the bearing sleeve.
12) Pull the bearing sleeve (item 8) off the spring plunger (item 7)
(2546884).
Inspection and lubrication
1) Check the cover cap (item 1) and the cover of the module (item 11) for
wear and tear and replace if they show signs of wear.
2) Check the bearing sleeve (item 8) and the stop pin (item 10) and replace
if they show signs of wear.
3) Apply a thin film of lubricant, only to the outer surfaces of the spring
holder (item 6). Make sure to avoid applying too much lubricant!
4) Carefully check and clean all components prior to assembling them.
Replace the components depending on the degree of wear.
See the section "Installing the reaction module" for the installation of the
reaction module.
9 Disposal
Dispose of the product in accordance with national regulations.
10 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthor­
ised modification of the product.
10.2 CE conformity
This product meets the requirements of the European Directive 93/42/EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
39