When Fitting Between Kitchen Cabinets; Moving The Range; Lowering The Two Rear Rollers - Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
*Note
5mm gap if the appliance is 30mm in front of
WORKTOP
the kitchen cabinets
9mm gap if the appliance is to be flush fitted
DOOR CHROME TRIM
between kitchen cabinets
DOOR HANDLE
check cookerhood instructions for actual dimensions
410 mm min
75 mm min
Wall
Height to Hotplate
910 mm min
935 mm max
*See note
*Note
5mm gap if the appliance is 30mm in front of the kitchen cabinets
9mm gap if the appliance is to be ush tted between kitchen cabinets
130 mm
Fig. 9.2
Fig. 9.3
INSTALLATION
Fig. 9.4
910 mm min
650 mm min
410 mm min
75 mm min
900 mm
Height to Flue Trim
925 mm min
950 mm max
*See note
Fig. 9.5
When Fitting Between Kitchen
Cabinets
We recommend that you either:
A.
Fit the range so that any cabinet doors are at least
30 mm behind the range door fronts. Note that this may
require an infill piece behind the range.
We recommend a gap of 910 mm between units to
allow for moving the range (Fig. 9.4). Do not box the
range in – it must be possible to move the range in and
out for cleaning and servicing.
Wall
B.
Leave a gap of at least 9 mm on either side of the range
(a 918 mm gap between units) (Fig. 9.4 and Fig. 9.5).
The range should be positioned centrally.
We also recommend that you do not final fix any adjacent
cabinets until the range is installed. Decorative mouldings or
handles on cabinet doors and fronts may interfere with the
opening of the oven doors.

Moving the range

On no account try and move the range while it is
n n
plugged into the electricity supply.
The range is very heavy, so take extra care.
n n
We recommend that two people manoeuvre the range. Make
sure that the floor covering is firmly fixed, or removed, to
prevent it being disturbed when moving the range around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt the
range backwards and remove the front half of the polystyrene
base (Fig. 9.2).
Repeat from the back and remove the rear half of the
polystyrene base.

Lowering the two rear rollers

To adjust the height of the rear of the range, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig. 9.3). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
26