Set The Governor; Pressure Testing; Affix Label - Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Fig. 11.5
ArtNo.103-0006 - Maxitrol cap & converter
Fig. 11.6
ArtNo.102-0007 - Maxitrol converter device positions
Nut
Snap-in converter device

Set the Governor

Unscrew the governor's brass top. In the base of the brass top
is a plastic snap-in converter device (Fig. 11.5). To convert the
governor, snap the device out of the top and refit it the other
way round. The snap-in converter device is marked to show
the gas for which it is set (Fig. 11.6).
Make sure the device is secure in the top cap and refit the cap
to the governor.

Pressure Testing

The pressure test point is accessible on the inlet pipe at the
rear. Remove the test nipple screw and fit a pressure gauge to
the test point. Turn on and light two of the hotplate burners.
For Propane X cookers the pressure should be 2.54 kPa.
Check the appliance is gas sound.
n n
Check operation of all the burners.
n n

Affix Label

Stick the appropriate gas label over the natural gas part of the
appliance data label.
33